Needle breaks

Replace the needle.

Important: Turn power switch to off ("O")!

Change the needles regularly, especially at the first signs of problems when sewing.

Insert the needle as in the illustration.
A. Loosen the needle clamp screw and tighten again after inserting the new needle.
B. The flat side of the shaft should be towards the back.
C/D. Insert the needle up to the stop at the end of the shaft.

Only use fully-functional needles.
Problems can occur with the use of:
- Bent needles
- Blunt needles
- Damaged points

The needle is not correctly inserted

Insert the needle correctly (flat side towards the back).

Important: Turn power switch to off ("O")!

Change the needles regularly, especially at the first signs of problems when sewing.

Insert the needle as in the illustration.
A. Loosen the needle clamp screw and tighten again after inserting the new needle.
B. The flat side of the shaft should be towards the back.
C/D. Insert the needle up to the stop at the end of the shaft.

Only use fully-functional needles.
Problems can occur with the use of:
- Bent needles
- Blunt needles
- Damaged points

Fabric too thick/ needle size wrong

Choose a needle size to suit the thread and fabric

tabelle

IMPORTANT: Match needle size to thread size and weight of fabric.

Please Note:

In general, fine threads and needles are used for sewing fine fabrics, and thicker threads are used for sewing heavy fabrics.
Always test thread and needle size on a small piece of fabric which will be used for actual sewing.
Use the same thread for needle and bobbin.
Use the stabilizer material for fine or stretchy fabrics, and select the correct presser foot.
The upper thread tension must be set at 2-3 when sewing the lightweight fabrics, like silk and jersey etc.

The wrong presser foot is attached

Use the correct presser foot.

Important: Turn the main switch to off ("O") when carrying out all the operations!
	1. Install the presser foot holder NRaise the presser bar (A) by lifting the two-step presser foot lifter Attach the presser foot holder (B) as illustrated. 2. Inserting the presser foot Lower the presser foot bar (B) until the groove (C) is directly above the pin (D). Lower the presser foot bar (A) as far as it will go. The presser foot (a) will engage automatically.

	3. Removing the presser foot Raise the presser foot. Press the lever (E) gently towards the front and the presser foot disengages. 4. Inserting the edge/ quilt guide (q) As shown in the illustration carefully insert the edge/ quilt guide (q) e.g. For hems, pleats, etc.

WELCOME

Needle breaks